CAD CAM EDM DRO - Yahoo Group Archive

plasma torch height control

Posted by Don Chandler
on 2001-09-07 18:43:16 UTC
Tom,
Check out www.shopbottools.com . They are coming out with a plasma cutter
unit along with their routers.
They are using the idea I proposed to you some time ago. They are adding a
voltage comparator inside the plasma cutter to monitor the arc voltage. The
software then controls the height. You can also raise and lower the torch by
pressing the page up-down keys while the torch is cutting. I think that Ted
told me that he would sell the electronics (ShopBot control box and card for
the plasma unit separately. I suspect this would only be slightly more than
the control from Austr.
Regards,
Don Chandler

Discussion Thread

Don Chandler 2001-09-07 18:43:16 UTC plasma torch height control tom@t... 2001-09-09 05:42:28 UTC Re: plasma torch height control Andy Olney 2001-09-09 08:00:54 UTC RE: [CAD_CAM_EDM_DRO] Re: plasma torch height control rfs@c... 2001-09-09 19:01:15 UTC Re: plasma torch height control tom@t... 2001-09-10 08:33:50 UTC Re: plasma torch height control N & K McLellan 2001-09-22 07:21:41 UTC Re: [CAD_CAM_EDM_DRO] Re: plasma torch height control