CAD CAM EDM DRO - Yahoo Group Archive

Re: plasma torch height control

Posted by rfs@c...
on 2001-09-09 19:01:15 UTC
--- In CAD_CAM_EDM_DRO@y..., "Andy Olney" <andy@o...> wrote:
> Try www.rutex.com for a plasma height control. Interesting site: it
also has a comparison of various step controlled servo products including their competitor to the gecko drives. Andy
>

I have been following topics re: plasma cutters. I have been
experimenting with plasma height control hardware via embedded pc. Trouble deciding how to determine torch height reliably. The Rutex unit looks very interesting. Does anyone have experience with this
product. Also the chart comparision between the Rutex servo driver
and other products is quite informative. Thanx for the url! rfs.

> -----Original Message-----
> From: tom@t... [mailto:tom@t...]
> Sent: Sunday, September 09, 2001 5:42 AM
> To: CAD_CAM_EDM_DRO@y...
> Subject: [CAD_CAM_EDM_DRO] Re: plasma torch height control
>
>
> --- In CAD_CAM_EDM_DRO@y..., "Don Chandler" <chandler@n...> wrote:
> > Tom,
> > Check out www.shopbottools.com . They are coming out with a plasma
> cutter
> > unit along with their routers.
>
> Don: An intense search of their website yielded no information on a
> Torch Height Control as a seperate component. Since I am flush with
> mechanical CNC components and already have my Plasma unit I am
> looking for just a height control electronics package. Yes, I could
> design my own but why go back through the learning curve? If they
> can offer the control electronics assembled and tested for less than
> Rutex within the next 30 days then I am a buyer. Can you give me a
> contact to contact about the upcoming unit?
>
> Thanks for the response.
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@y...
> Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> Moderator: jmelson@a... timg@k... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://d
ocs.yahoo.com/info/terms/

Discussion Thread

Don Chandler 2001-09-07 18:43:16 UTC plasma torch height control tom@t... 2001-09-09 05:42:28 UTC Re: plasma torch height control Andy Olney 2001-09-09 08:00:54 UTC RE: [CAD_CAM_EDM_DRO] Re: plasma torch height control rfs@c... 2001-09-09 19:01:15 UTC Re: plasma torch height control tom@t... 2001-09-10 08:33:50 UTC Re: plasma torch height control N & K McLellan 2001-09-22 07:21:41 UTC Re: [CAD_CAM_EDM_DRO] Re: plasma torch height control