Re: [CAD_CAM_EDM_DRO] Re: More on servo motor selection

>
> I have an Excel spreadsheet that you can just plug you variables into for
> this.
> If anyone is interested, I can post it.
> I would have done so earlier, but figured
> everyone's already been through this before me.
>
> After you've done that, you need to calculate the tangential forces of the
> cutter
> resultant from its being applied to the material.
>
> I tend to over-calculate these forces so that I don't come up short later
> on.
>
> Hope that helps,
>
> Weyland