Re: Minertia Servos on RF-31 mill?
Posted by
Ray
on 2001-10-01 06:00:25 UTC
From: Alan Marconett KM6VV <KM6VV@...>
Subject:
Alan
RadioShack adjustable power supply. At 30 volts it draws about 0.5 amp so
it is not exactly a workhorse.
The cable pulley here looks like it is pressed on and should come off with
a small bearing puller. This one does not have the three holes.
HTH
Ray
Subject:
Alan
> I have half a dozen or so MinertiaMotor T06M-Qu12 21v, 1300 rpm, 61I've got a similar one laying on the bench now. I'm spinning it with my
> oz/in servo motors, some used in daisy wheel printers. They are 3.25"
> dia, by 3.25" long. The ones from the printers have an analog shaft
> encoder, but not my new ones.
RadioShack adjustable power supply. At 30 volts it draws about 0.5 amp so
it is not exactly a workhorse.
The cable pulley here looks like it is pressed on and should come off with
a small bearing puller. This one does not have the three holes.
HTH
Ray
Discussion Thread
Alan Marconett KM6VV
2001-09-30 12:08:07 UTC
Minertia Servos on RF-31 mill?
Jon Elson
2001-09-30 15:09:06 UTC
Re: [CAD_CAM_EDM_DRO] Minertia Servos on RF-31 mill?
Ray
2001-10-01 06:00:25 UTC
Re: Minertia Servos on RF-31 mill?
Jon Elson
2001-10-01 10:29:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Minertia Servos on RF-31 mill?
Alan Marconett KM6VV
2001-10-01 10:56:22 UTC
Re: [CAD_CAM_EDM_DRO] Minertia Servos on RF-31 mill?
Alan Marconett KM6VV
2001-10-01 12:04:46 UTC
Re: Minertia Servos on RF-31 mill?
Jon Elson
2001-10-01 21:56:02 UTC
Re: [CAD_CAM_EDM_DRO] Minertia Servos on RF-31 mill?