CAD CAM EDM DRO - Yahoo Group Archive

Re: LINUX primer needed

Posted by Ernst Aardal
on 1999-10-11 23:20:06 UTC
You tell that Redhat 5.2 "actually installed easily" where did you find this
version of linux? Was it a iso image or did you make the 2 diskets?
Ernst

WAnliker@... wrote:

> From: WAnliker@...
>
> If someone that is a LINUX Guru, would make a list of LINUX commands and
> there equivalent in DOS, it might help a lot of us out in the learning curve.
> I see some commands that are very strange to me, and some that look similar
> to DOS commands.
> I feel that a lot of the problems with the LINUX install is related to the
> video board. Is there a low priced board on the market that would solve
> these problems? In my case I really don't know for sure what the video board
> characteristics are for sure, and that brought me to my knees, when
> installing the Xthingie. LINUX (Red Hat 5.2) actually installed easily, but
> that was the end of it so far. Shop temperature almost 90 degrees today.
> bill
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager

Discussion Thread

WAnliker@x... 1999-10-11 17:47:27 UTC LINUX primer needed Ernst Aardal 1999-10-11 23:20:06 UTC Re: LINUX primer needed