Re: Heidenhain Programming
Posted by
Paul Corner
on 1999-10-12 17:40:06 UTC
Hi Randolph
M25 - Home Z axiis, turn off coolant and stop spindle ready for a Tool change
M03 - Start spindle clockwise.
The TNC145 I use is fitted to a mill, hence some of the diferences in codes,
but the basics should still be the same.
I'll fire up the beast tomorrow, and check out nesting calls.
I would have thought that 20 - 30 quantities would have been viable on full
blown CNC. I just do model making so the numbers are low, yet CNC makes some
tasks so much easier. ( no axe to grind here ).
As for the teach in mode, I'm afraid I can not help you there - it's not a
function I have.
Regards, Paul.
M25 - Home Z axiis, turn off coolant and stop spindle ready for a Tool change
M03 - Start spindle clockwise.
The TNC145 I use is fitted to a mill, hence some of the diferences in codes,
but the basics should still be the same.
I'll fire up the beast tomorrow, and check out nesting calls.
I would have thought that 20 - 30 quantities would have been viable on full
blown CNC. I just do model making so the numbers are low, yet CNC makes some
tasks so much easier. ( no axe to grind here ).
As for the teach in mode, I'm afraid I can not help you there - it's not a
function I have.
Regards, Paul.
> the main differences seem to be in the"M" commands like M25, M03 etc
> where I guess TNC is commanding actual motion while the 855 would be
> just telling me where to go... I don't see anything like the M
> commands in the 855 code; I will try to DL this program to the 855 to
> see what it makes of it...
>
Discussion Thread
Paul Corner
1999-10-12 17:40:06 UTC
Re: Heidenhain Programming
Randolph Lee
1999-10-12 18:05:30 UTC
Re: Heidenhain Programming