Re: [CAD_CAM_EDM_DRO] Re: DC servo

Thanks for info
how can i use chanel A and B?
it is so small motor i think gear head is good but ratio is very high.
moter 218.4 rev and gear out is one.on 6 volts gear head output rev is
about 50.

shabbir

At 05:40 AM 10/19/01 +0000, you wrote:

>Shabbir,
>
>1- Ground
>2- Index Pulse
>3- Channel A
>4- +5VDC
>5- Channel B
>
>Very nice motor. Too bad there is a gearbox on it.
>
>Mariss
>
>--- In CAD_CAM_EDM_DRO@y..., "M. SHABBIR MOGHUL" <shabm@d...> wrote:
>> HI all
>> i have a DC servo with gear box. it is a small motor. it is 1.5
>inch in dia
>> length 3inch and gear box 2"X1.5". overall motor +gear box length
>is 4.5 inch.
>> it is from PITTMAN. USA
>> GM9412J818
>> 12 V DC 218.4:1 RATIO
>> 500 CPR (encoder plus/rev)
>> 01-12-96
>>
>> 2 wires of motor and 5 pin plug for encoder. but 4 wires are in
>encoder
>> plug one is open.
>> encoder wires are these.
>> 1 black
>> 2 open(no wire)
>> 3 yellow
>> 4 red
>> 5 blue
>>
>>
>> any one knows about encoder connections?
>> witch driver kit can be drive it?
>>
>> SHABBIR
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>