Re: Nesting of parts in BobCAM
Posted by
PTENGIN@x...
on 1999-05-21 03:04:41 UTC
In a message dated 5/20/99 6:49:43 PM Hawaiian Standard Time, pencad@...
writes:
<< The question I have now is, does anyone know the process for nesting
multiple parts into BobCAD? I tried the "copy", but that did not work.
Would I have to draw the multiple parts in AutoCAD and then export that
drawing with the cutting table dimensions already in place. >>
Bobcad uses a command called Translate after the drawing is selected. The
translate comand window allows copies and or movement. Peter
writes:
<< The question I have now is, does anyone know the process for nesting
multiple parts into BobCAD? I tried the "copy", but that did not work.
Would I have to draw the multiple parts in AutoCAD and then export that
drawing with the cutting table dimensions already in place. >>
Bobcad uses a command called Translate after the drawing is selected. The
translate comand window allows copies and or movement. Peter
Discussion Thread
Don Hughes
1999-05-20 21:48:11 UTC
Nesting of parts in BobCAM
john@x...
1999-05-21 01:23:18 UTC
Re: Nesting of parts in BobCAM
PTENGIN@x...
1999-05-21 03:04:41 UTC
Re: Nesting of parts in BobCAM
Mark Fraser
1999-05-21 05:28:54 UTC
Re: Nesting of parts in BobCAM
Jon Elson
1999-05-21 11:56:52 UTC
Re: Nesting of parts in BobCAM
Don Hughes
1999-05-21 12:19:21 UTC
Re: Nesting of parts in BobCAM