Re: Position Readout Question and Introduction
Posted by
PTENGIN@x...
on 1999-05-21 03:01:21 UTC
In a message dated 5/20/99 6:15:36 PM Hawaiian Standard Time,
mshaver@... writes:
<< Unfortunately, I don't know of any DRO maker that provides an output jack
for auxiliary connections. >>
Dear Matt,
In looking over information from Mitutoyo, they offer BCD and several
other output cards for the KC and other DRO systems. I have one of these
(KC) systems and was suspecting the output could be used to inteface to a
CNC. Also, in the MSC catalog, Mitutoyo used to list a linear spar to digital
output converter box. Peter
mshaver@... writes:
<< Unfortunately, I don't know of any DRO maker that provides an output jack
for auxiliary connections. >>
Dear Matt,
In looking over information from Mitutoyo, they offer BCD and several
other output cards for the KC and other DRO systems. I have one of these
(KC) systems and was suspecting the output could be used to inteface to a
CNC. Also, in the MSC catalog, Mitutoyo used to list a linear spar to digital
output converter box. Peter
Discussion Thread
George Potter
1999-05-20 17:11:33 UTC
Re: Position Readout Question and Introduction
Matt Shaver
1999-05-20 21:14:02 UTC
Re: Position Readout Question and Introduction
mike
1999-05-20 21:24:22 UTC
Re: Position Readout Question and Introduction
Jon Elson
1999-05-20 23:36:49 UTC
Re: Position Readout Question and Introduction
PTENGIN@x...
1999-05-21 03:01:21 UTC
Re: Position Readout Question and Introduction
George Potter
1999-05-21 21:55:38 UTC
Re: Position Readout Question and Introduction