Re: [CAD_CAM_EDM_DRO] G201 drives
Posted by
S.L.Ramsay
on 2001-10-23 15:53:05 UTC
I think the Gecko 320 and 340 are both 20 amp drivers, and less expensive
than the 201 (201A) for some strange reason.
Scott
than the 201 (201A) for some strange reason.
Scott
----- Original Message -----
From: "ron ginger" <ronginger@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, October 23, 2001 4:00 PM
Subject: [CAD_CAM_EDM_DRO] G201 drives
> I just got some of the old-rev G201 drives and have a couple questions.
> The web site has only the new G201A data.
>
> Are its pin-out identical to the G201A?
>
> Is it possible to disable the 10 microsteps, and have it run just
> straight single step mode?
>
> ron ginger
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
Discussion Thread
ron ginger
2001-10-23 15:48:53 UTC
G201 drives
S.L.Ramsay
2001-10-23 15:53:05 UTC
Re: [CAD_CAM_EDM_DRO] G201 drives
Tim
2001-10-23 16:37:26 UTC
RE: [CAD_CAM_EDM_DRO] G201 drives
Tim
2001-10-23 17:01:34 UTC
RE: [CAD_CAM_EDM_DRO] G201 drives