CAD CAM EDM DRO - Yahoo Group Archive

Re: need some gear boxes for twin screws

on 2001-10-26 11:08:10 UTC
Doug,
I haven't been there but have been thinking about it. I had planned
to use a cog belt between the twing screws on a smaller router. Do
you think that would work?

Also... Gates is selling toothed belting by the foot for use as gear
racks. I wonder how that would work in place of screws.

Roger

--- In CAD_CAM_EDM_DRO@y..., Doug Fortune <pentam@h...> wrote:
> carlcnc@e... wrote:
> >
> > I have considered that but need to make sure any backlash is the
> > same in both boxes. These will be driving twin screws on a gantry.
> >
> > Carl
> >
>
> I am a great fan of twin X screws in gantry designs. For all the
> complication involved, I'd suggest instead going with dual motors
> instead of a single motor driving a jackshaft.
>
> My 2 cents, because I've been there....
>
> Doug Fortune
> http://www.cncKITS.com

Discussion Thread

Doug Fortune 2001-10-26 08:56:32 UTC Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws carlcnc@e... 2001-10-26 09:43:24 UTC Re: need some gear boxes for twin screws Alan Marconett KM6VV 2001-10-26 10:49:07 UTC Re: need some gear boxes for twin screws vrsculptor@h... 2001-10-26 11:08:10 UTC Re: need some gear boxes for twin screws Bob Campbell 2001-10-26 12:37:09 UTC Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws Les Watts 2001-10-26 19:17:08 UTC Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws Jon Elson 2001-10-26 23:10:35 UTC Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws