Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws
Posted by
Bob Campbell
on 2001-10-26 12:37:09 UTC
Doug,
I may try two lead screws on my gantry machine to eliminate racking. I also
have some controller software that allows me to rack my machine (with two
motors on the Y axis) when I home the machine to get it square.
Bob Campbell
I may try two lead screws on my gantry machine to eliminate racking. I also
have some controller software that allows me to rack my machine (with two
motors on the Y axis) when I home the machine to get it square.
Bob Campbell
----- Original Message -----
From: "Doug Fortune" <pentam@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, October 26, 2001 10:48 AM
Subject: Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws
> carlcnc@... wrote:
> >
> > I have considered that but need to make sure any backlash is the
> > same in both boxes. These will be driving twin screws on a gantry.
> >
> > Carl
> >
>
> I am a great fan of twin X screws in gantry designs. For all the
> complication involved, I'd suggest instead going with dual motors
> instead of a single motor driving a jackshaft.
>
> My 2 cents, because I've been there....
>
> Doug Fortune
> http://www.cncKITS.com
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
Discussion Thread
Doug Fortune
2001-10-26 08:56:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws
carlcnc@e...
2001-10-26 09:43:24 UTC
Re: need some gear boxes for twin screws
Alan Marconett KM6VV
2001-10-26 10:49:07 UTC
Re: need some gear boxes for twin screws
vrsculptor@h...
2001-10-26 11:08:10 UTC
Re: need some gear boxes for twin screws
Bob Campbell
2001-10-26 12:37:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws
Les Watts
2001-10-26 19:17:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws
Jon Elson
2001-10-26 23:10:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes for twin screws