CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions

Posted by Tim Goldstein
on 2001-10-27 13:19:26 UTC
> -----Original Message-----

> Probably screws. I'm waiting to see what one of my friends comes up
> with. I'm just looking for a ballpark range so I can go through
> and see if
> there is anything lying around I can use.

My SWAG would be in the 150 in/oz range. I am basing this on the idea that
cutting forces will likely be similar to a Sherline setup and they do just
great with very nice rapids on a good low inductance 150 in/oz NEMA 23
motor.

Tim
[Denver, CO]

Discussion Thread

npalen@n... 2001-10-27 08:38:34 UTC CNC HOT WIRE FOAM CUTTING npalen@n... 2001-10-27 08:40:55 UTC CNC HOT WIRE FOAM CUTTING ccs@m... 2001-10-27 08:53:32 UTC Re: [CAD_CAM_EDM_DRO] CNC HOT WIRE FOAM CUTTING Dan Mauch 2001-10-27 10:43:41 UTC Home Shop Organization- Roll Around tool/ PC Robert Adams 2001-10-27 12:03:57 UTC Newbie introduction/Questions Tim Goldstein 2001-10-27 12:38:59 UTC RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions Robert Adams 2001-10-27 13:03:53 UTC RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions Tim Goldstein 2001-10-27 13:19:26 UTC RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions npalen@n... 2001-10-27 14:03:38 UTC Re: CNC HOT WIRE FOAM CUTTING jesse 2001-10-27 16:12:37 UTC Re: [CAD_CAM_EDM_DRO] Re: CNC HOT WIRE FOAM CUTTING Tom Murray 2001-10-27 21:16:29 UTC Re: CNC HOT WIRE FOAM CUTTING Andrew Werby 2001-10-28 13:34:04 UTC Re: CNC HOT WIRE FOAM CUTTING