CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions

Posted by Tim Goldstein
on 2001-10-27 12:38:59 UTC
> -----Original Message-----
> My questions are in general what strength motors should I be looking
> for and where can I get plans to build a controller that will supply
> adequate power to them.
> I have been doing a lot of looking on the net and searching the
> archives of this list and have come up with lots of valuable info.

Lots of details required to make a firm answer. How will the axis's be
driven? If you are using screws you get a lot of reduction and the motors
can be smaller to handle the cutting loads than if you are using rack and
pinion or direct belt drive (like on many printers).

> Geckos or anything similar are not an option. I don't have a problem
> building any of it but a pre etched board and schematics would be nice if
> not too expensive.

I don't follow your comment that Gecko's or similar is not an option. Is
this just a budgetary constraint? I have built some of my own controllers
using the L297/298 chip sets and when it was done and said I probably had
$35 per axis in hard costs and I made my own board. If you add a commercial
board for about $20 or so a piece you are now at $55 per axis. I can sell
you a closeout original version Gecko G201 for not much more than that and
it will work right of the bat and you will not be limited to the 2 amps a
L297/298 setup is.



Tim
[Denver, CO]

>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>

Discussion Thread

npalen@n... 2001-10-27 08:38:34 UTC CNC HOT WIRE FOAM CUTTING npalen@n... 2001-10-27 08:40:55 UTC CNC HOT WIRE FOAM CUTTING ccs@m... 2001-10-27 08:53:32 UTC Re: [CAD_CAM_EDM_DRO] CNC HOT WIRE FOAM CUTTING Dan Mauch 2001-10-27 10:43:41 UTC Home Shop Organization- Roll Around tool/ PC Robert Adams 2001-10-27 12:03:57 UTC Newbie introduction/Questions Tim Goldstein 2001-10-27 12:38:59 UTC RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions Robert Adams 2001-10-27 13:03:53 UTC RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions Tim Goldstein 2001-10-27 13:19:26 UTC RE: [CAD_CAM_EDM_DRO] Newbie introduction/Questions npalen@n... 2001-10-27 14:03:38 UTC Re: CNC HOT WIRE FOAM CUTTING jesse 2001-10-27 16:12:37 UTC Re: [CAD_CAM_EDM_DRO] Re: CNC HOT WIRE FOAM CUTTING Tom Murray 2001-10-27 21:16:29 UTC Re: CNC HOT WIRE FOAM CUTTING Andrew Werby 2001-10-28 13:34:04 UTC Re: CNC HOT WIRE FOAM CUTTING