CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] computer power supply

on 2001-10-27 18:05:33 UTC
Hi Gerald,

I think you want to load the +5V, which should be the RED and BLACK.
You might need to draw 200ma, or even an amp to get it to regulate.

HTH

Alan KM6VV


Area51tats@... wrote:
>
> I am using a Packard Bell power supply model pb150. I know I know it is
> older then dirt but it should work for this project. I have tried putting
> resistors across the black and yellow leads and the fan motor spins but slows
> down almost immediatly. I tried differnet sized resistors from 100 ohm to 470
> k and it didnt seem to make a difference in how long the fan spun. Am I
> doing something wrong?
>
> Gerald
> Iowa

Discussion Thread

Area51tats@a... 2001-10-27 08:04:28 UTC [CAD_CAM_EDM_DRO] computer power supply Alexandre GuimarĂ£es 2001-10-27 09:49:52 UTC Re: [CAD_CAM_EDM_DRO] computer power supply cncdxf@a... 2001-10-27 10:08:46 UTC Re: computer power supply Tim Goldstein 2001-10-27 10:38:50 UTC RE: [CAD_CAM_EDM_DRO] computer power supply cncdxf@a... 2001-10-27 10:52:35 UTC Re: computer power supply Eric Keller 2001-10-27 11:07:10 UTC Re: [CAD_CAM_EDM_DRO] computer power supply Alan Marconett KM6VV 2001-10-27 12:12:36 UTC Re: [CAD_CAM_EDM_DRO] computer power supply Area51tats@a... 2001-10-27 13:49:52 UTC Re: [CAD_CAM_EDM_DRO] computer power supply cncdxf@a... 2001-10-27 14:29:01 UTC Re: computer power supply Area51tats@a... 2001-10-27 16:50:37 UTC Re: [CAD_CAM_EDM_DRO] Re: computer power supply Alan Marconett KM6VV 2001-10-27 18:05:33 UTC Re: [CAD_CAM_EDM_DRO] computer power supply Jon Elson 2001-10-27 21:15:21 UTC Re: [CAD_CAM_EDM_DRO] computer power supply Jon Elson 2001-10-27 21:40:45 UTC Re: [CAD_CAM_EDM_DRO] computer power supply Jon Elson 2001-10-27 22:17:07 UTC Re: [CAD_CAM_EDM_DRO] computer power supply brian 2001-10-28 07:13:49 UTC Re: [CAD_CAM_EDM_DRO] computer power supply brian 2001-10-28 07:13:51 UTC Re: [CAD_CAM_EDM_DRO] computer power supply pcfw 2003-04-02 15:52:41 UTC computer power supply JanRwl@A... 2003-04-02 16:15:41 UTC Re: [CAD_CAM_EDM_DRO] computer power supply pcfw 2003-04-03 17:39:06 UTC Re: computer power supply (thanks) JanRwl@A... 2003-04-03 22:48:16 UTC Re: [CAD_CAM_EDM_DRO] Re: computer power supply (thanks)