CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] 80/20

on 2001-10-27 18:51:19 UTC
> HighTech wrote:
>
> table. How much does this stuff normally cost? I might need more.
> Derek

Derek

I have a catalog here, hope you are sitting down. These prices are about
a year old so it may well be higher now.

1" X 1" - .21 / inch
1" X 3" - .52 / inch
2" X 2" - .54 / inch
2" X 4" - .99 / inch

1.5" X 1.5" - .50 / inch
1.5" X 3" - .88 / inch
3" X 3" - 1.39 / inch
3" X 6" - 2.80 / inch

Once you start adding in the brackets, T Nuts, cutting charges etc
the cost of the extrusion is only part of the cost.
The 1" X 1" stuff is too light for all but the lightest duty router. 1.5" X
3"
works good, 3" X 3" is even better.

Bill

Discussion Thread

HighTech 2001-10-26 15:34:58 UTC 80/20 Chris L 2001-10-26 18:23:34 UTC Re: [CAD_CAM_EDM_DRO] 80/20 HighTech 2001-10-26 18:58:26 UTC RE: [CAD_CAM_EDM_DRO] 80/20 Chris L 2001-10-26 19:50:56 UTC Re: [CAD_CAM_EDM_DRO] 80/20 William Scalione 2001-10-27 18:51:19 UTC Re: [CAD_CAM_EDM_DRO] 80/20 JanRwl@A... 2001-10-27 19:18:13 UTC Re: [CAD_CAM_EDM_DRO] 80/20