Re: [CAD_CAM_EDM_DRO] Home Shop Organization- Roll Around tool/ PC

Best Regards,

Suntorn Suksiri
Project Engineer
webmaster@...
Information Technology Center Co.,Ltd.
Tel. +(66) 29963282-3,29963978
+(66) 19192454,14076192
Fax. +(66) 29963979
http://www.goods-th.com

----- Original Message -----
From: Dan Mauch <dmauch@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, October 28, 2001 9:23 PM
Subject: RE: [CAD_CAM_EDM_DRO] Home Shop Organization- Roll Around tool/ PC


> Not on my servo system. I use a variety or G code interpreters to run my
> servo amps. The programs will stop a servo motor if the encoder cable
> was connected but once you loose that connection the motors take off
> running.
> I am not aware of a single program that will stop the machine once a
> encoder cable comes loose unless there is some other external add on
> circuitry added
> Dan
> -----Original Message-----
> From: Steve Smith [mailto:sos@...]
> Sent: Saturday, October 27, 2001 7:19 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] Home Shop Organization- Roll Around tool/
> PC
>
> While I envy your use of roll around tools (my main area is dirt and
> rock), I
> have a question about your Y axis. Wouldn't a limit switch take care of
> the
> problem also?
>
> Steve Smith
>
> Dan Mauch wrote:
>
> > I am not claiming to be the most organized guy and it seems
> like
> > my shop is always a mess. Every day I clean and straighten things up
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>