Re: [CAD_CAM_EDM_DRO] step and direction software

Hi Brent,

You might want to look at SuperCAM:

http:\\www.camtronics.com

I see the price has just been reduced! Also, there are shareware and
free controllers available, TurboCNC comes to mind. Check the FAQ's,
I'll leave the stuff at the bottom of my post, which you may not have
seen if you are a journal viewer.

Alan KM6VV


brent davidson wrote:

>
> hello, i am looking for software to run a simple 2 axis gantry system
> with simple on off tool control, similar to a simple 2 axis plasma
> cutter. i have checked out ability systems indexer lpt and master 5,
> however these two seem to be overkill for my app. Any suggestions on
> this to keep it simple. basically just need hpgl import, set start
> coordinates and cut til done, emergency stop, etc.
>
> P.s,
>
> this group is wonderful and has helped me alot. keep up the fine work.
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/