Re: [CAD_CAM_EDM_DRO] EMC I/O Config
Posted by
JanRwl@A...
on 2001-11-17 19:11:18 UTC
In a message dated 17-Nov-01 18:51:15 Central Standard Time,
shymu@... writes:
you. Using the 754HCT4514, you can suddenly have 260 bits from the 8! How
to use, I can tell ya, but not "in the group"! Would be too many
questions/responses/opinions.
Jan Rowland
[Non-text portions of this message have been removed]
shymu@... writes:
>Frank: E-mail me direct, and I will discuss the details of your quest with
> Is there a way to config the printer port so I can turn on or off
> spindle and vac motors. I know about adding a second port but would
> rather not. Seems to me I should be able to run 4 axes and still have
> two lines left to control a spindle and vac system.
>
>
you. Using the 754HCT4514, you can suddenly have 260 bits from the 8! How
to use, I can tell ya, but not "in the group"! Would be too many
questions/responses/opinions.
Jan Rowland
[Non-text portions of this message have been removed]
Discussion Thread
shymu@b...
2001-11-17 16:50:39 UTC
EMC I/O Config
JanRwl@A...
2001-11-17 19:11:18 UTC
Re: [CAD_CAM_EDM_DRO] EMC I/O Config
JanRwl@A...
2001-11-17 19:20:54 UTC
Re: [CAD_CAM_EDM_DRO] EMC I/O Config
Alan Marconett KM6VV
2001-11-17 19:32:28 UTC
Re: [CAD_CAM_EDM_DRO] EMC I/O Config
Ray
2001-11-18 15:07:05 UTC
Re: EMC I/O Config
shymu@b...
2001-11-18 17:32:42 UTC
Re: EMC I/O Config