Re: Quad encoder to single ?

After I hit the post button I realized my ,..... anyway I'm running
EMC and not having a speed problem, and was just thinking about pulses
from EMC. Do you know the max per sec that EMC can send. Just looking
at ways to keep CPU overhead down.

Frank

--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
> Probably the least expensive way to go is to get the G901 board to
turn the
> drive into a G340. Then you can set to move 1,2,5, or 10 4X
quadrature
> counts per incoming pulse. $35 per board if I remember correctly.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> >
> > Can I just use A or B channel. and pull high the open line.
> > These are Gecko drives. Just don't need the resolution. Would
lower
> > pulses per second.
> >
> > Frank
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/