Re: eproms

It is possible but ,.... Most commercial controllors use software
feedback for encoders. The hardware would not be able to handle step
and direction software. Now your setup is steppers, open loop? And I
think EMCO MAIER is a dos based system. Be nice to fit CncPro on the prom.

Eprom programmers are less than a 100 bucks. I programmed many for
fuel injected cars. Mostly just read one prom and copied to another.

Frank

--- In CAD_CAM_EDM_DRO@y..., "FIK" <vrojas@p...> wrote:
> IS it possible to reprogram the eproms on an EMCO MAIER so they coould
> interpret and execute nc files from Vector or other programs?
>