Re: [CAD_CAM_EDM_DRO] DRO questions for laptop?

It should not be too hard for someone who has done bus interfacing
before to wire the chip from that card up to run off an EPP or ECP
mode parallel port. If you want to run the motors off the same port,
you would probably have to do some serious low-level hacking of the
control program.

If you aren't ready to tackle that level of project, you are probably
better off keeping the servo loop outside of the computer, or buying a
new computer with a slot for the card.

Chris

> I have a DRO board kit from Camtronics that I have yet to install,
> originally I was going to put it in my big bulky PC, but now I have a
> newer laptop that I plan on using to control my CNC conversion setup.
>
> Since the DRO kit has a board which needs to be installed in the
> computer, what can I use for my laptop or am I out of luck?
>
> The CNC conversion is a servo system with rotary encoders on the
> motors, but I also have the US Digital strip linear encoders as well
> which I had planned on using in the first place.
>
> Thanks,
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>

-------------------------------------------------
Christopher C. Stratton
Engineer, Instrument Maker, and Horn Player
ccs@... 617 628 1062
http://web.mit.edu/~stratton/www/brassbuild.html