CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] plasma on mill

Posted by Jon Elson
on 2001-11-28 22:22:25 UTC
Don Chandler wrote:

> Roger,
> I bolted a piece of 6" channel to my mill table. It extended out about 4 ft.
> in front of the mill. The plasma torch was mounted on the end of it. I put a
> small water tank under it to catch the sparks, dust and smoke. The mill had
> an Anilam series M control on it. I cut a series of slots in 16 ga.
> stainless sheet. It worked real well. Try to keep the crud the plasma
> produces off the ways of the mill.

Wow! that's a pretty sharp idea!

Jon

Discussion Thread

Don Chandler 2001-11-28 18:49:20 UTC plasma on mill vrsculptor@h... 2001-11-28 19:21:48 UTC Re: plasma on mill Jon Elson 2001-11-28 22:22:25 UTC Re: [CAD_CAM_EDM_DRO] plasma on mill machines@n... 2001-11-29 01:03:56 UTC Re: plasma on mill Chris Clough 2001-12-03 12:44:52 UTC Ballscrew and Gear Tim 2001-12-03 13:00:13 UTC RE: [CAD_CAM_EDM_DRO] Ballscrew and Gear Art Fenerty 2001-12-03 13:02:06 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew and Gear Chris Clough 2001-12-03 13:06:59 UTC RE: [CAD_CAM_EDM_DRO] Ballscrew and Gear Alan Marconett KM6VV 2001-12-03 14:57:12 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew and Gear