RE: [CAD_CAM_EDM_DRO] flat on shaft
Posted by
Tim Goldstein
on 2001-12-05 22:05:53 UTC
I have done it a number of times by just clamping the motor down to the
table with a hold down clamp pressing on the top of the mounting flange.
Then I hook the motor to a drive so it locks the shaft. Now happily mill
away. Very fast.
Tim
[Denver CO]
table with a hold down clamp pressing on the top of the mounting flange.
Then I hook the motor to a drive so it locks the shaft. Now happily mill
away. Very fast.
Tim
[Denver CO]
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>
Discussion Thread
cadcamcenter
2001-12-05 17:52:42 UTC
flat on shaft
Jerry Dees
2001-12-05 18:18:24 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Alan Marconett KM6VV
2001-12-05 19:02:52 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Marcus & Eva
2001-12-05 21:17:12 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
ccs@m...
2001-12-05 21:18:58 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
wanliker@a...
2001-12-05 21:55:56 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Alan Marconett KM6VV
2001-12-05 21:56:18 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Tim Goldstein
2001-12-05 22:05:53 UTC
RE: [CAD_CAM_EDM_DRO] flat on shaft
Marcus & Eva
2001-12-06 07:46:14 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Alan Marconett KM6VV
2001-12-06 10:24:56 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Tim
2001-12-06 10:38:42 UTC
RE: [CAD_CAM_EDM_DRO] flat on shaft
Smoke
2001-12-06 11:00:04 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Smoke
2001-12-06 11:05:54 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
cadcamcenter
2001-12-06 12:39:40 UTC
Re: flat on shaft
cadcamcenter
2001-12-06 12:54:42 UTC
Re: flat on shaft
Alan Marconett KM6VV
2001-12-06 14:28:31 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft
Smoke
2001-12-06 16:39:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: flat on shaft
wanliker@a...
2001-12-06 21:44:19 UTC
Re: [CAD_CAM_EDM_DRO] flat on shaft