Re: [CAD_CAM_EDM_DRO] running brushless servos with emc

----- Original Message -----
From: carlcnc <carlcnc@...>

> I am the very lucky owner of a 3axis setup that has brushless servos.
> Draw back is that control system was via delta-tau cards.
> Amplifiers are copely 10v+- signals. I need help/advice on what I
> need to add so I can use EMC for control.

You could try www.rutex.com and look for their step input to +/-10V output
cards (R997A, $73). Then you could use any step pulse output control
software.

Doug