Re: [CAD_CAM_EDM_DRO] I need help defining cutter compensation (Offset?) in Dolphin CAD/CAM (More Info)
Posted by
glee@i...
on 2001-12-15 12:51:15 UTC
I experimented further and found some additional information.
The sample part is 1" square and I am using a 1/8" .125 end mill to cut to
a depth of 1/8"
I had incorrectly stated in the previous post that my part was 1/16"
smaller on all sides.
In actuality, it appears that the cutter must be following the contour and
staying either to the left or the right. EIther way, I guess I am missing
something.
Thanks.
The sample part is 1" square and I am using a 1/8" .125 end mill to cut to
a depth of 1/8"
I had incorrectly stated in the previous post that my part was 1/16"
smaller on all sides.
In actuality, it appears that the cutter must be following the contour and
staying either to the left or the right. EIther way, I guess I am missing
something.
Thanks.
Discussion Thread
glee@i...
2001-12-15 12:51:15 UTC
Re: [CAD_CAM_EDM_DRO] I need help defining cutter compensation (Offset?) in Dolphin CAD/CAM (More Info)
stevenson_engineers
2001-12-15 13:46:00 UTC
Re: I need help defining cutter compensation (Offset?) in Dolphin CAD/CAM (More Info)
glee@i...
2001-12-15 15:46:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: I need help defining cutter compensation (Offset?) in Dolphin CAD/CAM (More Info)
Smoke
2001-12-15 20:00:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: I need help defining cutter compensation (Offset?) in Dolphin CAD/CAM (More Info)
glee@i...
2001-12-15 20:05:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: I need help defining cutter compensation (Offset?) in Dolphin CAD/CAM (More Info)