CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: shielded cable

Posted by Drew Rogge
on 2001-12-20 07:57:23 UTC
I purchased some of the CA-3934 cables for the setup I'm building.
A couple of things worth mentioning are that there isn't any strain
relief on the connector end and that the shielding is foil with a
drain wire. It's been mentioned on the list that foil shielding has a
tendency to break due to the continual flexing of the cable. Other
than that they seem to be working fine for now.

Drew

chewy8833 wrote:
>
> --- In CAD_CAM_EDM_DRO@y..., "npp67420" <npalen@n...> wrote:
> > Hello all. Wondering if anyone might know of a mail order source
> for
> > small quantity of shielded cable? Needing 22 or 24 gauge with four
> > twisted pair in a flexible cable for connecting axis encoders to the
> > drives.
> > Happy holidays!!!!
> > Thanks
> > Nelson
>
> You might want to take a look at this site
> http://www.usdigital.com/products/connect/5pin-standard.shtml Look
> around under different encoders because they group their cables based
> on encoder type
>
> I ran my power wiring using 18 ga two wire extension cord from Wal
> mart. then used the US Digital shielded cable designed for encoders.
>
> Makes a nice two cable setup to each axis
>
> Frank
>

--
Drew Rogge
drew@...

Discussion Thread

npp67420 2001-12-19 22:26:00 UTC shielded cable Doug Fortune 2001-12-19 23:00:05 UTC Re: [CAD_CAM_EDM_DRO] shielded cable npp67420 2001-12-20 05:13:35 UTC Re: shielded cable Peter Seddon 2001-12-20 07:05:38 UTC Re: [CAD_CAM_EDM_DRO] Re: shielded cable chewy8833 2001-12-20 07:22:22 UTC Re: shielded cable Drew Rogge 2001-12-20 07:57:23 UTC Re: [CAD_CAM_EDM_DRO] Re: shielded cable