Re: New on EMC: How to set the steps per unit for each axis? for metric
Posted by
natural_born_cadler
on 2001-12-21 09:57:00 UTC
--- In CAD_CAM_EDM_DRO@y..., "William Scalione" <wscalione@n...>
wrote:
thanks for the answer.
Oh, yes i have changed the "Linear value"
to 1.0000000.
(I tried to keep the digits on the same lentgh than the original
value)
The BDI for EMC is 2.0
The kernel is 2.2.18. rtl3.0 and it is installed on a PII 233MHZ.
So as long as i keep the inch units the jog works but the lentgh are
not correct. But when changed to unit 1 and other input value i
couldnt get it working.
I tried also changing Output value but i guess i is not needed
because encoders are not present.
Any idea ? I am sorry but i am totally new to linux.
thanks again,
frank
wrote:
> Frank,Planner
>
> First, what is in the "Linear Units" variable in the Trajectory
> section?and you
> if it is something like .03937XXXX then it is set up for inches,
> need to change that to "1". As far as the locking up, what versionof
> the BDI are you using?Hello Bill,
>
> Bill
thanks for the answer.
Oh, yes i have changed the "Linear value"
to 1.0000000.
(I tried to keep the digits on the same lentgh than the original
value)
The BDI for EMC is 2.0
The kernel is 2.2.18. rtl3.0 and it is installed on a PII 233MHZ.
So as long as i keep the inch units the jog works but the lentgh are
not correct. But when changed to unit 1 and other input value i
couldnt get it working.
I tried also changing Output value but i guess i is not needed
because encoders are not present.
Any idea ? I am sorry but i am totally new to linux.
thanks again,
frank
Discussion Thread
William Scalione
2001-12-21 09:36:43 UTC
Re: [CAD_CAM_EDM_DRO] New on EMC: How to set the steps per unit for each axis? for metric
natural_born_cadler
2001-12-21 09:57:00 UTC
Re: New on EMC: How to set the steps per unit for each axis? for metric
William Scalione
2001-12-21 11:24:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: New on EMC: How to set the steps per unit for each axis? for metric
natural_born_cadler
2001-12-21 13:25:00 UTC
Re: New on EMC: How to set the steps per unit for each axis? for metric
Ian Wright
2001-12-22 08:47:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: New on EMC: How to set the steps per unit for each axis? for metric