Re: Hobbiests Strike Again

Hi Dan and Paul,
This is my first encounter with the list. I was invited to join
yesterday...

Just to set the record straight, I do not mill any traces.... I etch my
circuit boards.

Wish I could find a simple through hole plating scheme for double sided
boards.

The boards are silver plated with CoolAmp, I prefer it to Tinit.

All PCB artwork is available for personal use at my web site.

regards
Hans Wedemeyer



Dan Mauch wrote:

> I looked at his PCB . What impressed me is that he is milling his traces.
> Dan
> -----Original Message-----
> From: Paul Devey <pdevey@...>
> To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
> Date: Wednesday, October 27, 1999 12:13 PM
> Subject: Re: [CAD_CAM_EDM_DRO] Hobbiests Strike Again
>
>
> >From: "Paul Devey" <pdevey@...>
> >
> >I have done so. He got back to me stating that he will check us out.
> >-----Original Message-----
> >From: Matt Shaver <mshaver@...>
> >To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
> >Date: Wednesday, October 27, 1999 12:35 AM
> >Subject: Re: [CAD_CAM_EDM_DRO] Hobbiests Strike Again
> >
> >
> >>From: "Matt Shaver" <mshaver@...>
> >>
> >>> From: "Paul Devey" <pdevey@...>
> >>>
> >>> Oh ya.
> >>>
> >>> His address is as follows:
> >>>
> >>> http://home.swbell.net/hans_w/index.htm
> >>> >Has anyone seen Hans Wedemeyer CNC controller designs on his web site?
> >He
> >>> has done a fine job. This may be of interest to Dan M.
> >>
>
>
>
> ------------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
> ----------------------------------------------------------------
> [Image]
> Click Here
>