Re: [CAD_CAM_EDM_DRO] Re: Just got my toy to work!

Any more information on this Router?

----- Original Message -----
From: "Alan Marconett KM6VV" <KM6VV@...>
To: "CAD CAM" <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, January 02, 2002 12:00 PM
Subject: [CAD_CAM_EDM_DRO] Re: Just got my toy to work!


> Hi WOODKNACK, Norm,
>
> As posted previously...
>
> Alan Marconett KM6VV wrote:
> >
> > Hi Norm,
> >
> > Right here! Name's Alan. 440.85 Mhz, pl...
> >
> > Actually, I might add, I didn't BUILD the router, I just posted the pix,
> > and studied the plans! It's built using ball bearing drawer slides,
> > 1/4"-20 threaded rod (as I recall), and small steppers. Dan wrote the
> > article, but doesn't have a reprint, and as you know, Nuts & Volts owns
> > it. I'd put out a call for Milton; "CQ CQ CQ Milton..." ;>)
> >
> > Seriously I'd contact Milton. Milton are you still listening? Or,
> > email me off list and I'll provide whatever info I can (for any and
> > all).
> >
> > You might also look at:
> >
> > http://hometown.aol.com/drigotti/HobbyCNC.htm
> >
> > Dave has an extensive set of router plans. Uses Kirk Motion parts.
> > Obviously more expensive! But depending what you are looking for...
> >
> > HTH
> >
> > Alan KM6VV
>
> Nuts and Volts may sell reprints. Milton arranged for me to see a copy
> of Dan's article. I posted Milton's pix for him.
>
> Your router project seems to be doing fine! Perhaps YOU could post
> plans for those interested.
>
> Alan KM6VV
>
>
> > Hello I posted pictures of my new toy I have been working on now for
> > sometime. Still not done have alot to do to it. Its in the photo
> > section under WOODKNACK. I saw some photos under the file section of
> > a modified Dan Mauch's machine. I tried to get ahold of the guy to
> > find out where I could get the plans, but had no luck. So I built it
> > with the photos he had in the file section. Just kind of wung it!
> > Did'nt come out to bad I think. Like I said still need to do alot
> > more to it. Total cost so far is around $300 dollars with everything
> > you see in the photos. Still need to buy a trim router for it..
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>