CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Mill/Drill CNC Conversion

Posted by ccs@m...
on 2002-01-11 07:18:34 UTC
> I figure I'd start with non-preloaded nuts as they are significantly
> less expensive than the preloaded ones ($20 vs. $160.) In my initial
> test of my table I found no perceivable backlash, but that of course
> will change once loads are applied. I guess I'll cross the backlash
> bridge when I come to it.

The preloaded nut I bought is really an assembly of two nuts. If I
had to do it again, I'd just buy two plain nuts. Dump the balls out,
grind two grooves in the end opposite the mounting threads of each, on
two opposite corners on each nut. Clean the nuts thorougly and repack
the balls. Then make up a short OD threaded tube to go between them
with male tabs to fit in the notches. Put some rings with set screw
lock on the threaded piece, and a stiff wavy washer type spring. Use
this to adjust the preload force...

Chris Stratton

Discussion Thread

jeffswayze 2002-01-10 12:31:08 UTC Mill/Drill CNC Conversion Alan Marconett KM6VV 2002-01-10 14:55:48 UTC Re: [CAD_CAM_EDM_DRO] Mill/Drill CNC Conversion jeffswayze 2002-01-10 15:19:48 UTC Re: Mill/Drill CNC Conversion Daniel J. Statman 2002-01-10 15:44:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Mill/Drill CNC Conversion Alan Marconett KM6VV 2002-01-10 15:53:05 UTC Re: Mill/Drill CNC Conversion jeffswayze 2002-01-10 17:54:43 UTC Re: Mill/Drill CNC Conversion Alan Marconett KM6VV 2002-01-10 18:49:59 UTC Re: Mill/Drill CNC Conversion ptengin@a... 2002-01-11 00:25:25 UTC Re: [CAD_CAM_EDM_DRO] Mill/Drill CNC Conversion jeffswayze 2002-01-11 07:11:27 UTC Re: Mill/Drill CNC Conversion ccs@m... 2002-01-11 07:18:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Mill/Drill CNC Conversion kaynrc 2002-01-11 09:00:21 UTC Re: Mill/Drill CNC Conversion dlantz@a... 2002-01-11 09:25:42 UTC RE: [CAD_CAM_EDM_DRO] Re: Mill/Drill CNC Conversion jeffswayze 2002-01-11 20:12:28 UTC Re: Mill/Drill CNC Conversion jeffswayze 2002-01-11 20:23:00 UTC Re: Mill/Drill CNC Conversion ballendo 2002-01-12 05:03:54 UTC Re: Mill/Drill CNC Conversion