Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
Posted by
Garry & Maxine Foster
on 2002-01-15 17:47:08 UTC
May I just say that you do good looking work!..
Nice easy site to navigate around also.
Garry
Nice easy site to navigate around also.
Garry
>
> In response to a previous post of mine, a lot of people asked if my
> Gecko Error/Reset controller was available for sale.
>
> At the time, I had no plans for any sort of "retail" activity, but there
> was enough interest that I relented.
>
> I added one more feature - the controller now has the ability to send an
> opto-isolated signal back to the PC in the event of a servo fault - and
> then had a small number of boards made up.
>
> Price is $20.00 USD for the pair, and another $8.00 for a programmed PIC.
>
> However, for those who prefer to "roll their own", complete information,
> including source code and Gerber layouts, has been made available.
>
> See my feeble web site at
>
> http://www.sfu.ca/~alan/gecko
>
> for more information.
>
> Alan
>
>
> --
>
> Alan Rothenbush | The Spartans do not ask the number of the
> Academic Computing Services | enemy, only where they are.
> Simon Fraser University |
> Burnaby, B.C., Canada | Agix of Sparta
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
Discussion Thread
Alan Rothenbush
2002-01-14 23:26:17 UTC
FS: Gecko G3x0 Error/Reset controller
Garry & Maxine Foster
2002-01-15 17:47:08 UTC
Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
Fitch R. Williams
2002-01-15 18:44:48 UTC
Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
wanliker@a...
2002-01-26 14:20:01 UTC
Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
Alan Rothenbush
2002-01-26 17:15:37 UTC
Re: FS: Gecko G3x0 Error/Reset controller