Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
Posted by
Fitch R. Williams
on 2002-01-15 18:44:48 UTC
Well done sir.
Fitch
On Mon, 14 Jan 2002 23:26:14 -0800 (PST), Alan Rothenbush <beer@...>
wrote:
Fitch
On Mon, 14 Jan 2002 23:26:14 -0800 (PST), Alan Rothenbush <beer@...>
wrote:
>
>In response to a previous post of mine, a lot of people asked if my
>Gecko Error/Reset controller was available for sale.
>
>At the time, I had no plans for any sort of "retail" activity, but there
>was enough interest that I relented.
>
>I added one more feature - the controller now has the ability to send an
>opto-isolated signal back to the PC in the event of a servo fault - and
>then had a small number of boards made up.
>
>Price is $20.00 USD for the pair, and another $8.00 for a programmed PIC.
>
>However, for those who prefer to "roll their own", complete information,
>including source code and Gerber layouts, has been made available.
>
>See my feeble web site at
>
> http://www.sfu.ca/~alan/gecko
>
>for more information.
>
>Alan
>
>
Discussion Thread
Alan Rothenbush
2002-01-14 23:26:17 UTC
FS: Gecko G3x0 Error/Reset controller
Garry & Maxine Foster
2002-01-15 17:47:08 UTC
Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
Fitch R. Williams
2002-01-15 18:44:48 UTC
Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
wanliker@a...
2002-01-26 14:20:01 UTC
Re: [CAD_CAM_EDM_DRO] FS: Gecko G3x0 Error/Reset controller
Alan Rothenbush
2002-01-26 17:15:37 UTC
Re: FS: Gecko G3x0 Error/Reset controller