Re: [CAD_CAM_EDM_DRO] Re: SeriesII Gecko210 voltage people use

Hi, nice article, but how can i download the whole article? I tried without
success. cul brian f.

----- Original Message -----
From: "janrwl" <JanRwl@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, January 22, 2002 1:08 PM
Subject: [CAD_CAM_EDM_DRO] Re: SeriesII Gecko210 voltage people use


> --- In CAD_CAM_EDM_DRO@y..., "studleylee" <indigo_red@q...> wrote:
> > Your ideas also got me thinking of experimenting by adding turns to
> > the primary, but on the outer layer. This would have a higher ratio
> > of affect than removing windings, and be less intrusive. I'm not a
> > transformer expert, so I'll do some reading up and have some
> articles on winding transformers. Also there was an interesting
> > spot welder from a microwave xformer website, that gave some
> insight.
> Lee:
>
> I wrote this Xfmr article years back, and I see Diana Todd still has
> it on her site. Thousands of people have read this, and many have
> asked me questions (on-line) about it. It's still "all good"!
>
> http://members.tripod.com/~schematics/xform/xformer1.htm
>
> I am not a "professional xfmr maker", but I DO have a LITTLE
> experience with that, so, if you still have quandaries, lemme know!
>
> Jan Rowland
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>