Driving unmarked steppers
Posted by
Paul
on 2002-02-14 13:01:15 UTC
Hi Guys
I have an oddball Type 34 stepper motor (six wire) without any numbers on it.
The windings both read approx 0.8 Ohms accross the full coil. What would be
the best way of determining the drive current with a Gecko 210 ?
Regards, Paul.
I have an oddball Type 34 stepper motor (six wire) without any numbers on it.
The windings both read approx 0.8 Ohms accross the full coil. What would be
the best way of determining the drive current with a Gecko 210 ?
Regards, Paul.
Discussion Thread
Paul
2002-02-14 13:01:15 UTC
Driving unmarked steppers
mariss92705
2002-02-14 13:21:48 UTC
Re: Driving unmarked steppers
NCS
2002-02-14 14:17:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers
Hugh Currin
2002-02-15 08:13:28 UTC
Re: Driving unmarked steppers
mariss92705
2002-02-15 09:41:51 UTC
Re: Driving unmarked steppers
Paul
2002-02-15 14:13:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers
Hugh Currin
2002-02-15 15:01:34 UTC
Re: Driving unmarked steppers
mariss92705
2002-02-15 15:38:41 UTC
Re: Driving unmarked steppers
Les Watts
2002-02-15 16:03:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers
ccs@m...
2002-02-15 17:06:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers
Les Watts
2002-02-15 20:47:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers
turbulatordude
2002-08-16 20:23:31 UTC
Mariss's Mystery Motors ( was Re: Driving unmarked steppers
turbulatordude
2002-08-16 20:33:40 UTC
Re: Driving unmarked steppers
mariss92705
2002-08-16 21:32:00 UTC
Mariss's Mystery Motors ( was Re: Driving unmarked steppers
rawen2
2002-08-17 09:16:47 UTC
Mariss's Mystery Motors ( was Re: Driving unmarked steppers
Alan Marconett KM6VV
2002-08-17 09:36:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers