CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers

on 2002-08-17 09:36:19 UTC
Here is one of Mariss' "mystery motor" papers.

Alan KM6VV

mariss92705 wrote:
>
> Hi,
>
> Here's what I use for "mystery motors":
>
> size 23, 1 stack -- 5W
> size 23, 2 stack -- 8W
> size 23, 3 stack -- 10W
>
> size 34, 1 stack -- 8W
> size 34, 2 stack -- 12W
> size 34, 3 stack -- 14W
>
> This applies to 6-wire round motors. It does not apply to the
> new "square" motors, but being new, they probably are not mystery
> motors either.
>
> When you measure the resistance, be sure to short the ohmmeter leads
> together first. Subtract the lead resistance resistance reading from
> whatever you read for the winding resistance.
>
> To improve accuracy a little more, measure the resistance of the end
> wires of the winding, subtract the lead resistance, then divide the
> result by 2 to get the center-tap to end-wire (unipolar) resistance
> of the motor.
>
> Mariss

Discussion Thread

Paul 2002-02-14 13:01:15 UTC Driving unmarked steppers mariss92705 2002-02-14 13:21:48 UTC Re: Driving unmarked steppers NCS 2002-02-14 14:17:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers Hugh Currin 2002-02-15 08:13:28 UTC Re: Driving unmarked steppers mariss92705 2002-02-15 09:41:51 UTC Re: Driving unmarked steppers Paul 2002-02-15 14:13:13 UTC Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers Hugh Currin 2002-02-15 15:01:34 UTC Re: Driving unmarked steppers mariss92705 2002-02-15 15:38:41 UTC Re: Driving unmarked steppers Les Watts 2002-02-15 16:03:17 UTC Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers ccs@m... 2002-02-15 17:06:14 UTC Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers Les Watts 2002-02-15 20:47:54 UTC Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers turbulatordude 2002-08-16 20:23:31 UTC Mariss's Mystery Motors ( was Re: Driving unmarked steppers turbulatordude 2002-08-16 20:33:40 UTC Re: Driving unmarked steppers mariss92705 2002-08-16 21:32:00 UTC Mariss's Mystery Motors ( was Re: Driving unmarked steppers rawen2 2002-08-17 09:16:47 UTC Mariss's Mystery Motors ( was Re: Driving unmarked steppers Alan Marconett KM6VV 2002-08-17 09:36:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Driving unmarked steppers