CAD CAM EDM DRO - Yahoo Group Archive

Re: ...power... Gecko ready stuff...FYI

Posted by studleylee
on 2002-02-14 15:46:26 UTC
Hi,
Bill at: www.grifftek.com has some nice power supplies ready for
Geckos.

On Ebay I've seen a nice triple heatsink Item # 1705441078
(http://cgi.ebay.com/aw-cgi/eBayISAPI.dll?ViewItem&item=1705441078)
ready for Geckos.

I would have gotten these if I didnt have tranformers and caps
already.


-Lee

--- In CAD_CAM_EDM_DRO@y..., "rsgoldner" <rgoldner@i...> wrote:
> Mariss, is this right? Given my three motors at 3V/4A phase driven
> by G201s do I need about 60V at 10A or 60V at 2A? Big difference in
> cost!
>
> --- In CAD_CAM_EDM_DRO@y..., NCS <ncs@n...> wrote:

Discussion Thread

NCS 2002-02-14 14:17:05 UTC Re: [CAD_CAM_EDM_DRO] Re: ...power... rsgoldner 2002-02-14 14:32:29 UTC Re: ...power... (Need Mariss) mariss92705 2002-02-14 14:56:05 UTC Re: ...power... mariss92705 2002-02-14 15:17:13 UTC Re: ...power... (Need Mariss) rsgoldner 2002-02-14 15:27:35 UTC Re: ...power... (Need Mariss) studleylee 2002-02-14 15:46:26 UTC Re: ...power... Gecko ready stuff...FYI dave_ace_me 2002-02-14 17:23:38 UTC uh, Mariss, can you clear up my confusion ? mariss92705 2002-02-14 17:57:53 UTC Re: uh, Mariss, can you clear up my confusion ? ccs@m... 2002-02-14 19:15:43 UTC Re: [CAD_CAM_EDM_DRO] uh, Mariss, can you clear up my confusion ? dave_ace_me 2002-02-14 20:09:27 UTC Re: uh, Mariss, can you clear up my confusion ? mariss92705 2002-02-14 22:17:24 UTC Re: uh, Mariss, can you clear up my confusion ? Jon Elson 2002-02-14 23:12:05 UTC Re: [CAD_CAM_EDM_DRO] Re: ...power... dave_ace_me 2002-02-15 05:06:57 UTC Re: uh, Mariss, can you clear up my confusion ? NCS 2002-02-21 14:47:27 UTC Re: [CAD_CAM_EDM_DRO] Re: ...power...