stuck
Posted by
lestur54424
on 2002-02-15 14:26:48 UTC
HI GUYS
I'M VERY NEW TO THE HOME CNC THING,I BOUGHT A HOBBYCNC STEPPER MOTOR
CARD FOR UNIPOLAR STEPPER MOTORS,IT CAME AS A KIT I PUT IT TOGETHER
AND ADDED AN AT COMPUTER POWER SUPPLY +12 VOLT AT .09 AMPS.I HAVE A
STEPPER MOTOR THAT IS 12 VOLTS AT.04 AMPS....I HAVE TURBOCNC SOFTWARE
ON A 486-66 COMPUTER.....NOTHING WORKS I'M PRETTY SURE THAT THE
STEPPER IS HOOKED UP RIGHT,WHEN I POWER UP THE STEPPER MOTOR IS
REALLY HARD TO TURN BY HAND BUT I GET NO MOVEMENT FROM THE SOFTWARE,I
THOUGHT THAT THE PARALLEL PORT WAS BAD SO I REPLACED IT AND THIS ONE
IS THE SAME.CAN SOMEBODY PLEASE HELP ME FIGURE THIS OUT ....
I'M VERY NEW TO THE HOME CNC THING,I BOUGHT A HOBBYCNC STEPPER MOTOR
CARD FOR UNIPOLAR STEPPER MOTORS,IT CAME AS A KIT I PUT IT TOGETHER
AND ADDED AN AT COMPUTER POWER SUPPLY +12 VOLT AT .09 AMPS.I HAVE A
STEPPER MOTOR THAT IS 12 VOLTS AT.04 AMPS....I HAVE TURBOCNC SOFTWARE
ON A 486-66 COMPUTER.....NOTHING WORKS I'M PRETTY SURE THAT THE
STEPPER IS HOOKED UP RIGHT,WHEN I POWER UP THE STEPPER MOTOR IS
REALLY HARD TO TURN BY HAND BUT I GET NO MOVEMENT FROM THE SOFTWARE,I
THOUGHT THAT THE PARALLEL PORT WAS BAD SO I REPLACED IT AND THIS ONE
IS THE SAME.CAN SOMEBODY PLEASE HELP ME FIGURE THIS OUT ....
Discussion Thread
lestur54424
2002-02-15 14:26:48 UTC
stuck
ccs@m...
2002-02-15 15:03:34 UTC
Re: [CAD_CAM_EDM_DRO] stuck
Raymond Heckert
2002-02-19 20:57:29 UTC
Re: [CAD_CAM_EDM_DRO] stuck