New looking for some help
Posted by
lestur54424
on 2002-02-16 15:03:32 UTC
HI
Read a lot of stuff the last two days on the site about cnc.I have a
hobbycnc 3-axis controller board with a at computer power
supply,running a vextra 12v .4a stepper motor with turbocnc
software,but nothing is working at all,the power resistors that i
figued i needed was 5-watt 30 ohm is this correct i have 60 ohm coils
on my motors..i need to learn a lot about this stuff,so all the info
you want to send would help....also would like to know which other
controller would be good to start off with on a buget and a source
for good motor,for now i would just like to start with a small
project that is a x-y-z table that i have
les
Read a lot of stuff the last two days on the site about cnc.I have a
hobbycnc 3-axis controller board with a at computer power
supply,running a vextra 12v .4a stepper motor with turbocnc
software,but nothing is working at all,the power resistors that i
figued i needed was 5-watt 30 ohm is this correct i have 60 ohm coils
on my motors..i need to learn a lot about this stuff,so all the info
you want to send would help....also would like to know which other
controller would be good to start off with on a buget and a source
for good motor,for now i would just like to start with a small
project that is a x-y-z table that i have
les