Re: [CAD_CAM_EDM_DRO] Troubleshooting, part II

> Try a min velocity of about 500

There's a "min. velocity" setting? Where?

and a max of 600. Use something like 50 for

> acceleration. Now, these numbers are too low to do any reasonable

machining,

> but we're trying to get the motors working.
>

Changed those to the reccomendations above, still nothing...

> What pin-outs have you set up in TurboCNC?

X Step: 3
X Dir: 2
Y Step: 5
Y Dir: 4
Z Step: 7
Z Dir: 6

How about an analog voltmeter?
I do have an analog meter; the direction pins are changeing approriately,
but I can't get a reading off the step pins. I don't know if that is because
it is not issuing steps, or if the meter simply can't read them?
I'm using Gecko drives; should I set the pins to be "active high" or "active
low"? I've tried both variations without luck.

Thanks,
Rick