Re: [CAD_CAM_EDM_DRO] Re: Troubleshooting, part II

> Put some BIG numbers in the speed setting parameters of stepster.
> Sounds like you're s/w is putting pulses out faster than the motor
> can move. You get movement at the beginning and end of the "move",
> since that's when the pulses are coming most slowly...

I did alter the numbers, and managed to get very smooth movement out of the
Y axis on one direction. It was rotating the proper number of times; but, it
still had that strange hesitation in the other direction, and still didn't
rotate the correct amount. The X axis still refused to move.