Re: [CAD_CAM_EDM_DRO] These prices are nuts ! was Re: tensioned ballscrew

----- Original Message -----
From: ballendo <ballendo@...>

> Yes, I'd believe it... Are you using one or two 10 foot axis screws?

Two screws, driven through two 600L timing belts to one motor in the middle.
I felt quite comfortable with a motor on each screw but couldn't come up
with a decent homing sequence using the software available (cncpro, master5,
ahha).

>
> Is this $950 for the rotating "rated", or the rotate-ABLE nuts? Or
> for the full assembly that Les pointed out?

Can't remember for sure. It's too darned much anyway.

Doug