EMCO compact lathe turret

The thickness of the turret plate is 22.2 mm, .874 in. It should not be
critical at all.
the holes for the bushings/boring bars are about 5/8 again not critical if
all are the same. But they should be on the centerlione of the lathe. They
have a slotted hole thru the side of the bushing, so that the set screw can
go thru and lock in the tool. There are two set screws, but only one hole in
the bushings that I have, they may be homemade, not sure.
The turret place is held on to the gear box, shaft by three screws, probably
a alignment bore on the underside.
bill