Re: Re: IT'S ALIVE!
Posted by
Robert Bachman
on 1999-12-01 08:33:13 UTC
Clint,
It's my understanding the max speed in EMC cannot be set seperately for
X, Y, & Z. I am not using EMC for that reason. My Z axis can only
handle ~40 ipm but the X & Y can do ~80 ipm. I am using AHHA software
because it allows individual max limits. I don't know about CNCPRO or
DESKNC.
Bob
It's my understanding the max speed in EMC cannot be set seperately for
X, Y, & Z. I am not using EMC for that reason. My Z axis can only
handle ~40 ipm but the X & Y can do ~80 ipm. I am using AHHA software
because it allows individual max limits. I don't know about CNCPRO or
DESKNC.
Bob
>On my machine the z axis is much slower than the x and y axis. Does
>this mean x and y will be held down to the speed limit of z? I sure
>hope not... Can the maximum speed of each axis be set individually?
>
>Thanks,
>
>Clint Bach
>
Discussion Thread
Clint Bach
1999-12-01 04:18:33 UTC
Re: IT'S ALIVE!
Jon Anderson
1999-12-01 07:50:02 UTC
Re: Re: IT'S ALIVE!
Tim Goldstein
1999-12-01 08:29:32 UTC
Re: Re: IT'S ALIVE!
Robert Bachman
1999-12-01 08:33:13 UTC
Re: Re: IT'S ALIVE!