RE: [CAD_CAM_EDM_DRO] Re: Ultimate free CAD system

oh... i was unclear. i meant INSTALL, not open, i seem to remember that the
install required me getting a code from the company, didn't it? every time
i reinstall? am i wrong.. it's been a while?---Dave L.

-----Original Message-----
From: rd@... [mailto:rd@...]
Sent: Monday, February 25, 2002 3:49 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Re: Ultimate free CAD system



Fred & Dave,

Have to correct you there gents. In fairness to PTC Software, once you have
the code and have it safely written down with all the other codes you have
that is the end of it. I have installed it on my laptop, (designing Live
Steam boilers at 36,000 ft) and also on my home PC using the same code in
both cases.

This was over a month ago and the only communication I have received from
the software manufacturer since was a invitation to participate in a free
on-line training presentation for this software last week. I did stay on
for most of it but seeing as how there is 16 hours time difference between
the vendor in the US and me in Western Australia, didn't quite make it to
the end :o))

Regards,

Russell Dunn
Perth
Western Australia
rd@...
http://people.mydesk.net.au/~rd/index.html

Date: Mon, 25 Feb 2002 15:23:59 -0500
From: dlantz@...
Subject: RE: Re: Ultimate free CAD system?

my memory is a bit fuzzy on this (it was awhile ago) but i seem to remember
having to get a registration code every time i load the software. now with
windows... that can be every two weeks! if the company were to go out of
bussiness, i would be out of luck.---Dave

-----Original Message-----
From: imserv@... [mailto:imserv@...]
Sent: Monday, February 25, 2002 8:10 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Re: Ultimate free CAD system?

--- In CAD_CAM_EDM_DRO@y..., dlantz@a... wrote:
> i tried the pro/DEsk too, it seemed very powerfull also, however the
> licencing thing was too constrictive for me

Can you explain that a little more Dave? I am concerned that you
noticed something that I might have missed. The only thing that stuck
in my mind was restrictions to exporting to certain countries on the
USA bad boy list.


Best Regards,

Fred Smith
IMService



--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

OFF Topic POSTS: General Machining
http://www.metalworking.com/news_servers.html
http://www.metalworking.com/news_servers.html

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Mom
List Owner



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/