Re: [CAD_CAM_EDM_DRO] Tool Changer -EMCO

In a message dated 2/26/2002 6:48:03 PM Mountain Standard Time,
gregg@... writes:

> I don'tknow whether there is a "feedback"
> connection to indicate to the board whether it has passed a set position or
>
> not.
>

The only electrics at the turret are the two wires to the motor, the timers
if any (has to be), are on the driver board, see my description on another
post. when I tested it, the time was consistant on the moves, unfortunately
did not write the times down.
By the motor has a heat sink on it, also a gear train between it and the worm
gear input.
bill


[Non-text portions of this message have been removed]