Re: [CAD_CAM_EDM_DRO] servo control card choices????
Posted by
Jon Elson
on 2002-02-26 23:06:01 UTC
nielsenbe@... wrote:
and digital I/O with 16 contact inputs and up to 8 SSR outputs. It connects
to the parallel port. The total cost in that configuration is $650.
See http://pico-systems.com/PPMC.html for more info.
This hardware is supported by EMC so far, but the interface details are
on the web pages, so you could write your own drivers or adapt any
other software that allows user-written drivers.
Jon
> I am getting a 2(minimum) axis servo control card that will be used forI have a 4-axis card set consisting of encoder counters, +/- 10V DACs
> closed loop electronic gearing. I have found at least ten on the net that
> would work. I was wondering if anyone has any personal experience good/bad on
> a similar controller. I am just trying to pick a brand they all seem to be
> $1100-1500 so any personal experience would be appreciated.
and digital I/O with 16 contact inputs and up to 8 SSR outputs. It connects
to the parallel port. The total cost in that configuration is $650.
See http://pico-systems.com/PPMC.html for more info.
This hardware is supported by EMC so far, but the interface details are
on the web pages, so you could write your own drivers or adapt any
other software that allows user-written drivers.
Jon
Discussion Thread
nielsenbe@a...
2002-02-26 02:17:32 UTC
servo control card choices????
Les Watts
2002-02-26 06:02:36 UTC
Re: [CAD_CAM_EDM_DRO] servo control card choices????
Doug Harrison
2002-02-26 08:07:25 UTC
Re: [CAD_CAM_EDM_DRO] servo control card choices????
Jon Elson
2002-02-26 23:06:01 UTC
Re: [CAD_CAM_EDM_DRO] servo control card choices????