Re: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
Posted by
Jon Elson
on 2002-02-26 23:11:42 UTC
riet91 wrote:
a memory error relating to corrupted page tables. Apparently, Linux
uses features that Windows doesn't use, and so machines that ran
Windows perfectly, or at least reasonably well, may croak almost
immediately under Linux.
What motherboard, CPU, etc. are you using? How much memory?
What size hard disk?
Jon
> Dear List memebers ,You may have hardware problems on that motherboard. Signal 11 is
> I have downloaded the BDI ISO image file, extracted it with Winimage
> software for windows and then created the CD using some CD writting
> software because my CD writing software does not open any file with
> extension img.When I tried to boot from this CD, it does not boot
> (although my system has the capability to boot from CD and it was
> properly configured to boot from CD, moreover I have also tried on
> some other systems also) .Then I made a bootable floopy from the DOS
> utility found in the BDI CD, system booted but Linux install failed
> with the following error:
>
> "install exited abnormally... received signal 11
> sending termination signals... done
> sending kill signals.... done
> disabling swap...
> unmounting filesystem
> /mnt/source
> /dev/pts
> ejecting CD ROM
a memory error relating to corrupted page tables. Apparently, Linux
uses features that Windows doesn't use, and so machines that ran
Windows perfectly, or at least reasonably well, may croak almost
immediately under Linux.
What motherboard, CPU, etc. are you using? How much memory?
What size hard disk?
Jon
Discussion Thread
riet91
2002-02-26 03:40:07 UTC
Help...please...BDI CD.........
Dave Lantz
2002-02-26 05:49:59 UTC
RE: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
awemawson
2002-02-26 12:04:58 UTC
Re: Help...please...BDI CD.........
riet91
2002-02-26 21:25:44 UTC
Re: Help...please...BDI CD.........
Jon Elson
2002-02-26 23:11:42 UTC
Re: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
Jon Elson
2002-02-26 23:13:57 UTC
Re: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
Paul
2002-02-27 15:15:10 UTC
Re: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
Flavio Luiz
2002-02-28 02:53:54 UTC
Re: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
riet91
2002-02-28 04:07:08 UTC
Re: Help...please...BDI CD.........
Jon Elson
2002-02-28 10:55:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help...please...BDI CD.........