CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Very small miller/engraver

on 2002-03-01 13:09:17 UTC
Hi Graham,

Welcome to the list! A lot of work is done on the Sherline/Taig/MaxNC
mills. You might want to start there.

There are micro positioning tables available surplus, I'd investigate
that, if you're looking to cobble your own.

Alan KM6VV


Graham Stabler wrote:
>
> Has anyone out there built anything in the way of really small mills/engravers. I only want to make small parts out of perspex, balsa, pcb and ocasionally aluminium. I've seen "The Brute" on the web and might buy the plans but just wanted to see if there were other alternatives.
>
> Cheers,
>
> Graham Stabler
>
> p.s. First post

Discussion Thread

Graham Stabler 2002-03-01 10:01:03 UTC Very small miller/engraver Alan Marconett KM6VV 2002-03-01 13:09:17 UTC Re: [CAD_CAM_EDM_DRO] Very small miller/engraver dave_ace_me 2002-03-01 13:44:57 UTC Re: Very small miller/engraver ballendo 2002-03-02 04:41:37 UTC Re: Very small miller/engraver Sven Peter 2002-03-02 04:58:57 UTC Re: [CAD_CAM_EDM_DRO] Re: Very small miller/engraver John H. 2002-03-02 05:18:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Very small miller/engraver Guy Sirois 2002-03-02 06:47:50 UTC RE: Homemade mill (was Very small miller/engraver) dave_ace_me 2002-03-02 07:47:52 UTC Re: Homemade mill (was Very small miller/engraver) Guy Sirois 2002-03-02 08:15:51 UTC RE: [CAD_CAM_EDM_DRO] Re: Homemade mill (was Very small miller/engraver) Gail & Bryan Harries 2002-03-02 08:21:03 UTC RE: [CAD_CAM_EDM_DRO] Very small miller/engraver dave_ace_me 2002-03-02 12:31:46 UTC Re: Homemade mill (was Very small miller/engraver) Tom Benedict 2002-03-02 13:43:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Very small miller/engraver