CAD CAM EDM DRO - Yahoo Group Archive

Gecko NEMA 42 Modifications - will I need it ??

Posted by ja_erickson
on 2002-03-02 16:06:17 UTC
Good Eve,

I'VE RECENTLY PURCHASED GECKO G201 DRIVERS FOR A BRIDGEPORT SERIES 1
RETROFIT PROJECT THAT I AM ATEMPTING. THE ORIGINAL MOTORS ARE RATED AT
56 VOLTS AND 8.25 AMPS. I HAVE BEEN WATCHING THIS GROUP AND HAVE
NOTICED THAT A MODIFICATION TO THESE DRIVES HAS BEEN MENTIONED,BUT
DO NOT KNOW IF I NEED THIS MODIFICATION OR WHY IT IS NEEDED IN THE
FIRST PLACE. I AM USING MICROKINETICS 75 VOLT - 5 AMP POWER SUPPLIES.
ANY SUGGESTIONS OR WARNINGS NOW MIGHT SAVE ME ALOT OF TROUBLES LATER.

THANKS
JEFF

Discussion Thread

ja_erickson 2002-03-02 16:06:17 UTC Gecko NEMA 42 Modifications - will I need it ?? audiomaker2000 2002-03-02 16:49:43 UTC Re: Gecko NEMA 42 Modifications - will I need it ?? Raymond Heckert 2002-03-02 18:02:06 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko NEMA 42 Modifications - will I need it ?? Peter 2002-03-03 06:35:05 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko NEMA 42 Modifications - will I need it ??